**DUE TO THE COVID-19 VIRUS, THERE WILL BE SHIPPING DELAYS ON POWERS/DEWALT PRODUCTS. THANK YOU AND SORRY FOR ANY INCONVENIENCE**
*ALL POWERS WEDGE BOLTS HAVE BEEN REPLACED BY DEWALT SCREW-BOLTS**
Toggle Bolt 3/16" Toggler® (w/o screws)
MPBAS10 $21.99Price per package of 10.Bulk pricing (10) packages / $199.90.MATERIALSIdeal for Heavy Loads in Hollow Walls, Ceilings & Floors—TOGGLER® brand SNAPTOGGLE® bolts pre-install without a bolt and can be installed with a screw gun. This allows one-person installations (instead of two).Attributes of TOGGLER® brand SNAPTOGGLE® bolts that make them superior to conventional toggle bolts, such as wing toggles or gravity toggles...Cost-effective: Turn a 2-person job into a 1-person job and get the job done faster. Save six minutes per anchor compared with old-fashioned methods. Strongest toggle bolt in smallest hole Convenient: Allow removal of bolt or fixture without anchor falling behind wall. Most reliable: Will not damage or break through wall even when vibrated. Easy to Use: Pre-install without bolt. Accurate: Rugged pre-installation mechanism centers metal channel in small hole, before bolt insertion—and bolt won't sag. Quick: Can be used with a screw gun—anchor won't spin in hole.Partitions Window treatments Sinks Shelving Marine applications (in stainless steel) Garage doors Hand rails Heavy fans Awnings Cabinets ADA hardware Lighting fixtures Roofing & decking DSS antennae TV brackets Heavy machinery Office furnitureTOGGLER® brand SNAPTOGGLE® bolts can be used in almost any hollow material, including:Hollow Block Cinder Block Concrete Block Cement Board Gypsum Board Drywall Hollow Brick Plaster Paneling Fiberglass Boat Decks Composite PanelsINSTALLATION DIRECTIONSA) Drill 1/2" (13mm) hole. Hold metal channel flat alongside plastic strap. Slide channel through hole.B) Hold ends of straps between thumb and forefinger and pull toward you until channel rests flush behind wall. Slide plastic cap along straps with other hand until flange of cap is flush with wall.C) Snap straps at wall by pushing side to side, snapping off straps level with flange of cap.D) Place item over flange. Insert bolt and tighten until snug against item, then stop. Use any like-threaded bolt (match thread in metal channel). Bolt length = fixture thickness + wall or ceiling thickness + 1/2" (13mm). Minimum clearance behind wall = 1-7/8" (48mm)TOGGLER® brand SNAPTOGGLE® bolts will not damage or break through walls, even under vibration. You can use a shorter bolt for every application, because you do not have to carry a wing through the wall.TOGGLER® brand SNAPTOGGLE® bolts require a smaller hole (1/2") than other toggle bolts and also hold more weight.PULL-OUT VALUES FOR 1/4"-20 BOLT306 lbs (162 kg) ultimate tensile load in 5/8" drywall925 lbs (420 kg) ultimate tensile load in concrete block1,283 lbs (583 kg) ultimate tensile load in steel plate1,735 lbs (789 kg) ultimate tensile load in steel plate with stainless steel SNAPTOGGLE® anchor.For more information, please visit website:http://www.toggler.com/products/snaptoggle/overview.php
Availabile: Usually ships same business day.
MPBAS10 $21.99